well the latch of the door seems to work fine and it locks itself in. But i think my dishwasher doesnt start because it thinks its door is not closed. i did this:
"Control board malfunction. To determine if the control board is malfunctioning, complete the rotary switch test as follows: 1. Power Dishwasher OFF then back ON ( the Washing, Drying and Clean LEDs will flash ON and OFF). 2. Press the Heat Dry, Delay Start and Start/Cancel keys at the same time until all 7 LEDs are flashing ON and OFF. 3. Open the door and all 7 LEDs will stay ON, but will stop flashing. 4. Shut the door and all 7 LEDs will go out. 5. Press the Start/Cancel key ( depending on the position of the Rotary Switch, a specific LED will come on.) 6. Rotary Switch position and corresponding LED indicators: Normal Wash LED above the Heat Dry button Pots and Pans LED under the 2 Light Wash LED under the 4 Upper Rack Washing LED Rinse Only Clean LED With each position of the Rotary Switch, push and pull the knob. If the led stays ON without flashing, go to the next position. If pushing and pulling the knob causes an LED to go out, replace the control."
So when i got to the part when I close the door and the 7lights have to go out, they dont. So this led me to believe that there is a closing problem. Should I change the rubber around the door or get a new door latch??
Any suggestions are welcome :)
Submitted December 23, 2014 at 02:57AM by redditceo12345 http://ift.tt/1ASfK97 fixit
No comments:
Post a Comment