Showing posts with label MechanicAdvice. Show all posts
Showing posts with label MechanicAdvice. Show all posts

Saturday, March 12, 2016

2012-2014 Izusu NPR gasoline with Thermoking unit will decide not to turn over, but will an hour and a half later. MechanicAdvice

This has happened a few times at my part time job. When I turn it over it will sound sluggish until eventually it will refuse to turn over at one of my delivery stops. It can take sometimes over 2 hours to get a jump so I try it occasionally. This time it did start without a jump and I continued with my delivery route after canceling the service. It continued to sound sluggish so I just turned off the refrigerated section and had no problem starting after.

Could this have been the culprit? The people who get my route together are supposed to plug in the refrigerator unit so it cools down with electrical power but sometimes like today they don't so the engine has to do that on the road.



Submitted March 13, 2016 at 06:17AM by Phoneaccountdickball http://ift.tt/1ReatVT MechanicAdvice

Thursday, December 17, 2015

Glow plug connectors MechanicAdvice

Hi diesel heads

Does anyone know where i can buy glow plug connectors? My glow plug harness is crispy due to old age and cold winters. Some of my connectors are broken or falling apart. I was looking to repair the harness but i cant seem to find loose connectors for sale anywhere. As they are standardized connectors do they have a universal technical name? I live in Norway so online stores would be preferable. Alternatively i could go to a scrapyard and get some but i need 5 so maybe id have to cut up two harnesses.



Submitted December 18, 2015 at 04:19AM by Loud_Refrigerator http://ift.tt/1QsCXKu MechanicAdvice

Wednesday, October 28, 2015

Need help fixing a refrigerator have the instructions manual. MechanicAdvice

The problem is that the freezer won't work. My dad thinks we have to adjust the temperature. This is the manual

http://ift.tt/1NBRJKH

where is the temperature adjuster located?



Submitted October 29, 2015 at 04:45AM by spitfire9107 http://ift.tt/1P6fV9U MechanicAdvice

Sunday, August 30, 2015

1999 Lincoln TownCar electrical issues MechanicAdvice

Had the car for about 8 months now no issues other than low freon. Battery was replaced may 2014.

While driving the other night the gauges were registering zero and the the turn signal was barely registering. This seems more prevalent while coasting or idling. Upon acceleration everything comes back on. I noticed while coasting/idling the AC is much more weak than when accelerating as well.

My first thought was the alternator, but could it be just an idle pulley? Belt looks to be in good condition with no noticeable slipping. Battery terminals are clean.

Should I just go ahead with an alternator? Idle Pulley? Both?



Submitted August 30, 2015 at 10:50PM by el_refrigerator http://ift.tt/1NH9I4C MechanicAdvice

Saturday, April 11, 2015

1968 Ford F100: Knock In Drivetrain MechanicAdvice


I have a 240cu motor with a T18 tranny. Running project a year off the farm. I have been driving off and on for the past year working out kinks but recently it has developed a new issue.


Theres a pretty severe knock somewhere after the motor. It's intermittent and only in gear. Its severe enough to buck the truck. It seems to happen higher in the RPM range but I have no tach to pinpoint where exactly.


If its bucking/knocking and I engage the clutch it instantly goes away. It feels more to the rear of the tranny, almost if someone is hitting the rear of the cab floor with a hammer. I can rev the motor up and and down in neutral or with the clutch engaged and doesn't skip a beat.


Could it be a broken spring in the clutch that goes out of whack with centrifugal forces at higher RPMs?


Something worn or loose in the tranny?


Bad carrier bearing at the half shaft causing the halfshaft to flail?


Something else?


Thanks







Submitted April 11, 2015 at 08:06PM by el_refrigerator http://ift.tt/1GW4f5w MechanicAdvice

Saturday, December 13, 2014

1992 Merc 190E - I need to part ways with it, but can't, in conscience, scrap it. What can i do? MechanicAdvice


Sorry if there's a better place for this, but i couldnt think of any place where i could find car lovers like you that were open to questions. So, when i got my license, my dad bought me a 1992 190E 2.3 with 170k miles. She was in rough shape, and didnt last long before it couldn't last any longer.


My local shop- a damned decent one just west of Indianapolis- states that she needs the head gasket replaced (which i knew upon driving her for the first time), a new fuel distributor, and fuel sensor. ~$3000.


My father didn't even pay 3k for the thing. It's not fiscally viable for us.


She's essentially a hole in my driveway, and i, like most 17 year old boys, really could use a working car. The thing is, the interior is in fantastic shape, she rides fantastically, and when she ran, she ran damned well. I can't send this machine to be crushed and made into refrigerators when i know someone, somewhere could save her.


So, what's the best way to keep a broken-down, 21 year-old, German luxury car with a nearly perfect interior from her scrapyard fate (and make back at least a little bit of what we paid for her)?







Submitted December 14, 2014 at 11:52AM by CptDepressing http://ift.tt/1wpETIB MechanicAdvice