This is a Main Control Board from a refrigerator where the technician's helper told him the power was off when it really wasn't.
One of the traces is burnt out where an arc occurred.
Can I jump this trace by soldering on a thick wire? I wouldn't think I'd have to worry too much about signal latency with this short of a jump.
The bad spot is on Pin 1 of JP12 in the 2nd link photo. Thanks!
Submitted August 05, 2015 at 11:24PM by g1mike http://ift.tt/1Uoy8kf AskElectronics
No comments:
Post a Comment